Crash with Display Splats

[pwestenb]

Load data/tutorials/turbine.am
Display->Splats
select ColorMap Physics.icol
click "Adjust Range"

http://www.tgs-europe.de/images/AvizoBoom.jpg

Happens on my M70, WinXP32

[forum_admin]

Hi Peter,

This bug is known and the good news is that it has been fixed in the development version.
It will be available in the next beta version.
FYI: this bug is due to a bad topology of the turbine.am mesh. It sohuldn't happen on a valid mesh.

Pascal

[jlgarnier]

I don't reproduce any crash when selecting "Adjust Range" (desktop WinXP 32bits) BUT I get a crash when trying to rotate the displayed geometry (messages displayed in the console : visibility cycle in mesh!).
It also happens if I don't select "Adjust Range".
Is it fixed ?
Could it be possible to get understandable messages in the console ?

JLuc

[forum_admin]

I don't reproduce any crash when selecting "Adjust Range" (desktop WinXP 32bits) BUT I get a crash when trying to rotate the displayed geometry (messages displayed in the console : visibility cycle in mesh!).
It also happens if I don't select "Adjust Range".
Is it fixed ?


Yes. Actually, it's a view dependent display algorihm. It crashes in some position but not always...


Could it be possible to get understandable messages in the console ?

JLuc

In the future version, internal errors will be catched to produce clear messages and avoid to stop the application.